Promethean PRM10 projector lamp
The Promethean PRM10 takes lamp POA-LMP126, a 200 W lamp . It is available both as a complete module (bulb fitted in its housing) and as a bare bulb for re-using your existing housing.
The code printed on your old lamp or its housing should match one of the codes listed above. Promethean and third-party suppliers sell the same lamp under several numbers.
The model number is on a label on the base or rear of the projector, and in the on-screen menu under Information. Still unsure? Send a photo of the old lamp and we'll confirm the match.
Which lamp does the Promethean PRM10 take?
The Promethean PRM10 uses POA-LMP126, also sold as 610 340 8569, 610-340-8569.
Should I buy the bare bulb or the module?
Both are available. The module is the bulb already fitted in its housing and is the quicker swap. The bare bulb is cheaper and re-uses your existing housing, but you move the bulb across yourself.
How long does the PRM10 lamp last?
Rated life depends on the lamp mode you run and how the projector is ventilated; the lamp's own page lists the figure where the manufacturer publishes one.
Does the same lamp fit other Promethean projectors?
Yes. The same lamp also fits the Promethean Active Board +2, the Promethean LMP126, the Promethean PRM10 LAMP, the Promethean PRM20, the Promethean PRM20 (S), the Promethean PRM20A and other Promethean models listed on this page.