Promethean PRM AB2-01 projector lamp
The Promethean PRM AB2-01 takes lamp POA-LMP126, a 200 W lamp . It is available both as a complete module (bulb fitted in its housing) and as a bare bulb for re-using your existing housing. The same lamp is also sold under 2 other part numbers, all listed below. It fits 16 Promethean models in total.
The code moulded into your old lamp or printed on its housing may be any of these. They are the same part. If the code on your lamp appears in this table, it fits the Promethean PRM AB2-01.
| Code | Used by |
|---|---|
POA-LMP126 | Promethean original part number |
610 340 8569 | Equivalent code |
610-340-8569 | Equivalent code |
The code printed on your old lamp or its housing should match one of the codes listed above. Promethean and third-party suppliers sell the same lamp under several numbers.
The model number is on a label on the base or rear of the projector, and in the on-screen menu under Information. Still unsure? Send a photo of the old lamp and we'll confirm the match.
If your projector is one of these rather than the PRM AB2-01, the same lamp is the correct part.
Which lamp does the Promethean PRM AB2-01 take?
The Promethean PRM AB2-01 uses POA-LMP126, also sold as 610 340 8569, 610-340-8569.
Should I buy the bare bulb or the module?
Both are available. The module is the bulb already fitted in its housing and is the quicker swap. The bare bulb is cheaper and re-uses your existing housing, but you move the bulb across yourself.
How long does the PRM AB2-01 lamp last?
Rated life depends on the lamp mode you run and how the projector is ventilated; the lamp's own page lists the figure where the manufacturer publishes one.
Does the same lamp fit other Promethean projectors?
Yes. The same lamp also fits the Promethean Active Board +2, the Promethean LMP126, the Promethean PRM10, the Promethean PRM10 LAMP, the Promethean PRM20, the Promethean PRM20 (S) and other Promethean models listed on this page.