Projection Design FL32 WUXGA projector lamp
The Projection Design FL32 WUXGA takes lamp 109-387A . It is available both as a complete module (bulb fitted in its housing) and as a bare bulb for re-using your existing housing.
The code printed on your old lamp or its housing should match one of the codes listed above. Projection and third-party suppliers sell the same lamp under several numbers.
The model number is on a label on the base or rear of the projector, and in the on-screen menu under Information. Still unsure? Send a photo of the old lamp and we'll confirm the match.
Which lamp does the Projection Design FL32 WUXGA take?
The Projection Design FL32 WUXGA uses 109-387A, also sold as Perception 003-000884-01, Perception 003-120198-01, Perception 109-387A, Perception 400-0400-00, Perception 400-0500-00, R9801272.
Should I buy the bare bulb or the module?
Both are available. The module is the bulb already fitted in its housing and is the quicker swap. The bare bulb is cheaper and re-uses your existing housing, but you move the bulb across yourself.
How long does the Design FL32 WUXGA lamp last?
Rated life depends on the lamp mode you run and how the projector is ventilated; the lamp's own page lists the figure where the manufacturer publishes one.
Does the same lamp fit other Projection projectors?
Yes. The same lamp also fits the Projection Design AVIELO Kroma, the Projection Design AVIELO Optix, the Projection Design AVIELO Optix 3D, the Projection Design AVIELO OPTIX 1080, the Projection Design AVIELO Optix SuperWide 235, the Projection Design Cineo3 and other Projection models listed on this page.