Projection Design F3+ SXGA+ (300w) projector lamp
The Projection Design F3+ SXGA+ (300w) takes lamp 109-387A . It comes as a complete module, with the bulb already fitted in its housing.
The code printed on your old lamp or its housing should match one of the codes listed above. Projection and third-party suppliers sell the same lamp under several numbers.
The model number is on a label on the base or rear of the projector, and in the on-screen menu under Information. Still unsure? Send a photo of the old lamp and we'll confirm the match.
Which lamp does the Projection Design F3+ SXGA+ (300w) take?
The Projection Design F3+ SXGA+ (300w) uses 109-387A, also sold as Perception 003-000884-01, Perception 003-120198-01, Perception 109-387A, Perception 400-0400-00, Perception 400-0500-00, R9801272.
Should I buy the bare bulb or the module?
This model's lamp is sold as a complete module: the bulb comes fitted in its housing, so you replace the whole unit in one piece.
How long does the Design F3+ SXGA+ (300w) lamp last?
Rated life depends on the lamp mode you run and how the projector is ventilated; the lamp's own page lists the figure where the manufacturer publishes one.
Does the same lamp fit other Projection projectors?
Yes. The same lamp also fits the Projection Design AVIELO Kroma, the Projection Design AVIELO Optix, the Projection Design AVIELO Optix 3D, the Projection Design AVIELO OPTIX 1080, the Projection Design AVIELO Optix SuperWide 235, the Projection Design Cineo3 and other Projection models listed on this page.