Optoma HT19 projector lamp
The Optoma HT19 takes lamp BL-FP230D, a 230 W lamp rated for 3,000 hours. It comes as a complete module, with the bulb already fitted in its housing. The same lamp is also sold under 2 other part numbers, all listed below. It fits 25 Optoma models in total.
The code moulded into your old lamp or printed on its housing may be any of these. They are the same part. If the code on your lamp appears in this table, it fits the Optoma HT19.
| Code | Used by |
|---|---|
BL-FP230D | Optoma original part number |
SP.8EG01GC01 | Equivalent code |
SP.8EG01G.C01 | Equivalent code |
The code printed on your old lamp or its housing should match one of the codes listed above. Optoma and third-party suppliers sell the same lamp under several numbers.
The model number is on a label on the base or rear of the projector, and in the on-screen menu under Information. Still unsure? Send a photo of the old lamp and we'll confirm the match.
If your projector is one of these rather than the HT19, the same lamp is the correct part.
Which lamp does the Optoma HT19 take?
The Optoma HT19 uses BL-FP230D, also sold as SP.8EG01GC01, SP.8EG01G.C01.
Should I buy the bare bulb or the module?
This model's lamp is sold as a complete module: the bulb comes fitted in its housing, so you replace the whole unit in one piece.
How long does the HT19 lamp last?
BL-FP230D is rated for 3,000 hours at 230 W. Actual life depends on the lamp mode you run and how the projector is ventilated.
Does the same lamp fit other Optoma projectors?
Yes. The same lamp also fits the Optoma DH1010, the Optoma EH1020, the Optoma EW615, the Optoma EW615i, the Optoma EX612, the Optoma EX615 and other Optoma models listed on this page.