Optoma EX615 projector lamp
The Optoma EX615 takes lamp BL-FP230D, a 230 W lamp rated for 3,000 hours. It is available both as a complete module (bulb fitted in its housing) and as a bare bulb for re-using your existing housing. The same lamp is also sold under 2 other part numbers, all listed below. It fits 25 Optoma models in total.
The code moulded into your old lamp or printed on its housing may be any of these. They are the same part. If the code on your lamp appears in this table, it fits the Optoma EX615.
| Code | Used by |
|---|---|
BL-FP230D | Optoma original part number |
SP.8EG01GC01 | Equivalent code |
SP.8EG01G.C01 | Equivalent code |
The code printed on your old lamp or its housing should match one of the codes listed above. Optoma and third-party suppliers sell the same lamp under several numbers.
The model number is on a label on the base or rear of the projector, and in the on-screen menu under Information. Still unsure? Send a photo of the old lamp and we'll confirm the match.
If your projector is one of these rather than the EX615, the same lamp is the correct part.
Which lamp does the Optoma EX615 take?
The Optoma EX615 uses BL-FP230D, also sold as SP.8EG01GC01, SP.8EG01G.C01.
Should I buy the bare bulb or the module?
Both are available. The module is the bulb already fitted in its housing and is the quicker swap. The bare bulb is cheaper and re-uses your existing housing, but you move the bulb across yourself.
How long does the EX615 lamp last?
BL-FP230D is rated for 3,000 hours at 230 W. Actual life depends on the lamp mode you run and how the projector is ventilated.
Does the same lamp fit other Optoma projectors?
Yes. The same lamp also fits the Optoma DH1010, the Optoma EH1020, the Optoma EW615, the Optoma EW615i, the Optoma EX612, the Optoma EX615i and other Optoma models listed on this page.