TEQ CPA222WNLAMP projector lamp
The TEQ CPA222WNLAMP takes lamp DT01251, a 210 W lamp rated for 3,000 hours. It comes as a complete module, with the bulb already fitted in its housing. The same lamp is also sold under 2 other part numbers, all listed below. It fits 7 TEQ models in total.
The code moulded into your old lamp or printed on its housing may be any of these. They are the same part. If the code on your lamp appears in this table, it fits the TEQ CPA222WNLAMP.
| Code | Used by |
|---|---|
DT01251 | TEQ original part number |
CPA222WNLAMP | Equivalent code |
456-8104WB | Equivalent code |
The code printed on your old lamp or its housing should match one of the codes listed above. TEQ and third-party suppliers sell the same lamp under several numbers.
The model number is on a label on the base or rear of the projector, and in the on-screen menu under Information. Still unsure? Send a photo of the old lamp and we'll confirm the match.
If your projector is one of these rather than the CPA222WNLAMP, the same lamp is the correct part.
Which lamp does the TEQ CPA222WNLAMP take?
The TEQ CPA222WNLAMP uses DT01251, also sold as CPA222WNLAMP, 456-8104WB.
Should I buy the bare bulb or the module?
This model's lamp is sold as a complete module: the bulb comes fitted in its housing, so you replace the whole unit in one piece.
How long does the CPA222WNLAMP lamp last?
DT01251 is rated for 3,000 hours at 210 W. Actual life depends on the lamp mode you run and how the projector is ventilated.
Does the same lamp fit other TEQ projectors?
Yes. The same lamp also fits the TEQ DT01181, the TEQ DT01381, the TEQ TEQ-Z781N, the TEQ TEQ-Z782WN, the TEQ TEQ-Z801N, the TEQ TEQ-ZW751N.