Sharp XV-Z10000U projector lamp
The Sharp XV-Z10000U takes lamp AN-K10LP . It comes as a complete module, with the bulb already fitted in its housing. The same lamp is also sold under 1 other part number, all listed below. It fits 6 Sharp models in total.
The code moulded into your old lamp or printed on its housing may be any of these. They are the same part. If the code on your lamp appears in this table, it fits the Sharp XV-Z10000U.
| Code | Used by |
|---|---|
AN-K10LP | Sharp original part number |
BQC-XVZ100001 | Equivalent code |
The code printed on your old lamp or its housing should match one of the codes listed above. Sharp and third-party suppliers sell the same lamp under several numbers.
The model number is on a label on the base or rear of the projector, and in the on-screen menu under Information. Still unsure? Send a photo of the old lamp and we'll confirm the match.
If your projector is one of these rather than the XV-Z10000U, the same lamp is the correct part.
Which lamp does the Sharp XV-Z10000U take?
The Sharp XV-Z10000U uses AN-K10LP, also sold as BQC-XVZ100001.
Should I buy the bare bulb or the module?
This model's lamp is sold as a complete module: the bulb comes fitted in its housing, so you replace the whole unit in one piece.
How long does the XV-Z10000U lamp last?
Rated life depends on the lamp mode you run and how the projector is ventilated; the lamp's own page lists the figure where the manufacturer publishes one.
Does the same lamp fit other Sharp projectors?
Yes. The same lamp also fits the Sharp XV-Z1000, the Sharp XV-Z1000E, the Sharp XV-Z10000, the Sharp XV-Z10000E, the Sharp XV-Z10000K.