Sanyo PLC-SU51 projector lamp
The Sanyo PLC-SU51 takes lamp LV-LP19 / 03-000754-02P, a 200 W lamp rated for 1,500 hours. It is available both as a complete module (bulb fitted in its housing) and as a bare bulb for re-using your existing housing. The same lamp is also sold under 4 other part numbers, all listed below. It fits 9 Sanyo models in total.
The code moulded into your old lamp or printed on its housing may be any of these. They are the same part. If the code on your lamp appears in this table, it fits the Sanyo PLC-SU51.
| Code | Used by |
|---|---|
LV-LP19 | Sanyo original part number |
03-000754-02P | Sanyo original part number |
03-000754-02P | Equivalent code |
610-307-7925 | Equivalent code |
POA-LMP65 | Equivalent code |
LV-LP19 | Equivalent code |
The code printed on your old lamp or its housing should match one of the codes listed above. Sanyo and third-party suppliers sell the same lamp under several numbers.
The model number is on a label on the base or rear of the projector, and in the on-screen menu under Information. Still unsure? Send a photo of the old lamp and we'll confirm the match.
If your projector is one of these rather than the PLC-SU51, the same lamp is the correct part.
Which lamp does the Sanyo PLC-SU51 take?
The Sanyo PLC-SU51 uses LV-LP19 / 03-000754-02P, also sold as 03-000754-02P, 610-307-7925, POA-LMP65, LV-LP19.
Should I buy the bare bulb or the module?
Both are available. The module is the bulb already fitted in its housing and is the quicker swap. The bare bulb is cheaper and re-uses your existing housing, but you move the bulb across yourself.
How long does the PLC-SU51 lamp last?
LV-LP19 is rated for 1,500 hours at 200 W. Actual life depends on the lamp mode you run and how the projector is ventilated.
Does the same lamp fit other Sanyo projectors?
Yes. The same lamp also fits the Sanyo LMP65, the Sanyo PLC-SL20, the Sanyo PLC-SU50, the Sanyo PLC-SU50S, the Sanyo PLC-XU25A, the Sanyo PLC-XU50A and other Sanyo models listed on this page.