Sanyo PDG-DXL2000E projector lamp
The Sanyo PDG-DXL2000E takes lamp POA-LMP143 . It comes as a complete module, with the bulb already fitted in its housing. The same lamp is also sold under 2 other part numbers, all listed below. It fits 5 Sanyo models in total.
The code moulded into your old lamp or printed on its housing may be any of these. They are the same part. If the code on your lamp appears in this table, it fits the Sanyo PDG-DXL2000E.
| Code | Used by |
|---|---|
POA-LMP143 | Sanyo original part number |
610 351 3744 | Equivalent code |
610-351-3744 | Equivalent code |
The code printed on your old lamp or its housing should match one of the codes listed above. Sanyo and third-party suppliers sell the same lamp under several numbers.
The model number is on a label on the base or rear of the projector, and in the on-screen menu under Information. Still unsure? Send a photo of the old lamp and we'll confirm the match.
If your projector is one of these rather than the PDG-DXL2000E, the same lamp is the correct part.
Which lamp does the Sanyo PDG-DXL2000E take?
The Sanyo PDG-DXL2000E uses POA-LMP143, also sold as 610 351 3744, 610-351-3744.
Should I buy the bare bulb or the module?
This model's lamp is sold as a complete module: the bulb comes fitted in its housing, so you replace the whole unit in one piece.
How long does the PDG-DXL2000E lamp last?
Rated life depends on the lamp mode you run and how the projector is ventilated; the lamp's own page lists the figure where the manufacturer publishes one.
Does the same lamp fit other Sanyo projectors?
Yes. The same lamp also fits the Sanyo DWL2500, the Sanyo DXL2000, the Sanyo PDG-DWL2500, the Sanyo PDG-DXL2000.