Projection Design F30 (250W) projector lamp
The Projection Design F30 (250W) takes lamp 400-0300-00 . It is available both as a complete module (bulb fitted in its housing) and as a bare bulb for re-using your existing housing.
The code printed on your old lamp or its housing should match one of the codes listed above. Projection and third-party suppliers sell the same lamp under several numbers.
The model number is on a label on the base or rear of the projector, and in the on-screen menu under Information. Still unsure? Send a photo of the old lamp and we'll confirm the match.
Which lamp does the Projection Design F30 (250W) take?
The Projection Design F30 (250W) uses 400-0300-00, also sold as Design 400-0300-00.
Should I buy the bare bulb or the module?
Both are available. The module is the bulb already fitted in its housing and is the quicker swap. The bare bulb is cheaper and re-uses your existing housing, but you move the bulb across yourself.
How long does the Design F30 (250W) lamp last?
Rated life depends on the lamp mode you run and how the projector is ventilated; the lamp's own page lists the figure where the manufacturer publishes one.
Does the same lamp fit other Projection projectors?
Yes. The same lamp also fits the Projection Design ACTION 3, the Projection Design ACTION 3 1080, the Projection Design CINEO 3, the Projection Design F3, the Projection Design F3 SX+ (250W), the Projection Design F3 XGA (250W) and other Projection models listed on this page.