Projection Design F12 SX (300w) projector lamp
The Projection Design F12 SX (300w) takes lamp R9801270 / 400-0401-00, a 300 W lamp rated for 2,000 hours. It is available both as a complete module (bulb fitted in its housing) and as a bare bulb for re-using your existing housing.
The code printed on your old lamp or its housing should match one of the codes listed above. Projection and third-party suppliers sell the same lamp under several numbers.
The model number is on a label on the base or rear of the projector, and in the on-screen menu under Information. Still unsure? Send a photo of the old lamp and we'll confirm the match.
Which lamp does the Projection Design F12 SX (300w) take?
The Projection Design F12 SX (300w) uses R9801270 / 400-0401-00, also sold as 400-0401-00, Projection 107-750, Projection 109-689, Design 400-0401-00, Design R9801270.
Should I buy the bare bulb or the module?
Both are available. The module is the bulb already fitted in its housing and is the quicker swap. The bare bulb is cheaper and re-uses your existing housing, but you move the bulb across yourself.
How long does the Design F12 SX (300w) lamp last?
R9801270 is rated for 2,000 hours at 300 W. Actual life depends on the lamp mode you run and how the projector is ventilated.
Does the same lamp fit other Projection projectors?
Yes. The same lamp also fits the Projection Design AVIELO Radiance, the Projection Design Cineo10, the Projection Design Cineo12, the Projection Design F1+ SX+ wide (300w), the Projection Design F10, the Projection Design F10 1080 and other Projection models listed on this page.