Philips LC3132/99 projector lamp
The Philips LC3132/99 takes lamp LCA3116, a 132 W lamp rated for 6,000 hours. It is available both as a complete module (bulb fitted in its housing) and as a bare bulb for re-using your existing housing. It fits 20 Philips models in total.
The code moulded into your old lamp or printed on its housing may be any of these. They are the same part. If the code on your lamp appears in this table, it fits the Philips LC3132/99.
| Code | Used by |
|---|---|
LCA3116 | Philips original part number |
The code printed on your old lamp or its housing should match one of the codes listed above. Philips and third-party suppliers sell the same lamp under several numbers.
The model number is on a label on the base or rear of the projector, and in the on-screen menu under Information. Still unsure? Send a photo of the old lamp and we'll confirm the match.
If your projector is one of these rather than the LC3132/99, the same lamp is the correct part.
Which lamp does the Philips LC3132/99 take?
The Philips LC3132/99 uses LCA3116.
Should I buy the bare bulb or the module?
Both are available. The module is the bulb already fitted in its housing and is the quicker swap. The bare bulb is cheaper and re-uses your existing housing, but you move the bulb across yourself.
How long does the LC3132/99 lamp last?
LCA3116 is rated for 6,000 hours at 132 W. Actual life depends on the lamp mode you run and how the projector is ventilated.
Does the same lamp fit other Philips projectors?
Yes. The same lamp also fits the Philips BSURE SV1, the Philips BSURE SV2, the Philips BTENDER, the Philips GARBO, the Philips GARBO Home Cinema, the Philips GARBO Matchline and other Philips models listed on this page.