Optoma OP260ST projector lamp
The Optoma OP260ST takes lamp BL-FP230F, a 230 W lamp rated for 3,000 hours. It is available both as a complete module (bulb fitted in its housing) and as a bare bulb for re-using your existing housing. The same lamp is also sold under 2 other part numbers, all listed below. It fits 25 Optoma models in total.
The code moulded into your old lamp or printed on its housing may be any of these. They are the same part. If the code on your lamp appears in this table, it fits the Optoma OP260ST.
| Code | Used by |
|---|---|
BL-FP230F | Optoma original part number |
SP.8JA01G.C01 | Equivalent code |
SP.8JA01GC01 | Equivalent code |
The code printed on your old lamp or its housing should match one of the codes listed above. Optoma and third-party suppliers sell the same lamp under several numbers.
The model number is on a label on the base or rear of the projector, and in the on-screen menu under Information. Still unsure? Send a photo of the old lamp and we'll confirm the match.
If your projector is one of these rather than the OP260ST, the same lamp is the correct part.
Which lamp does the Optoma OP260ST take?
The Optoma OP260ST uses BL-FP230F, also sold as SP.8JA01G.C01, SP.8JA01GC01.
Should I buy the bare bulb or the module?
Both are available. The module is the bulb already fitted in its housing and is the quicker swap. The bare bulb is cheaper and re-uses your existing housing, but you move the bulb across yourself.
How long does the OP260ST lamp last?
BL-FP230F is rated for 3,000 hours at 230 W. Actual life depends on the lamp mode you run and how the projector is ventilated.
Does the same lamp fit other Optoma projectors?
Yes. The same lamp also fits the Optoma 95.8JA11GC0E, the Optoma DB3601, the Optoma DB3603, the Optoma EW605ST, the Optoma EW605ST-EDU, the Optoma EW610ST and other Optoma models listed on this page.