Optoma CM10 projector lamp
The Optoma CM10 takes lamp SP.8EH01GC01 / BL-FU185A, a 185 W lamp rated for 3,000 hours. It is available both as a complete module (bulb fitted in its housing) and as a bare bulb for re-using your existing housing. The same lamp is also sold under 3 other part numbers, all listed below. It fits 25 Optoma models in total.
The code moulded into your old lamp or printed on its housing may be any of these. They are the same part. If the code on your lamp appears in this table, it fits the Optoma CM10.
| Code | Used by |
|---|---|
SP.8EH01GC01 | Optoma original part number |
BL-FU185A | Optoma original part number |
BL-FU185A | Equivalent code |
SP.8EH01G.C01 | Equivalent code |
SP.8EH01GC01 | Equivalent code |
The code printed on your old lamp or its housing should match one of the codes listed above. Optoma and third-party suppliers sell the same lamp under several numbers.
The model number is on a label on the base or rear of the projector, and in the on-screen menu under Information. Still unsure? Send a photo of the old lamp and we'll confirm the match.
If your projector is one of these rather than the CM10, the same lamp is the correct part.
Which lamp does the Optoma CM10 take?
The Optoma CM10 uses SP.8EH01GC01 / BL-FU185A, also sold as BL-FU185A, SP.8EH01G.C01, SP.8EH01GC01.
Should I buy the bare bulb or the module?
Both are available. The module is the bulb already fitted in its housing and is the quicker swap. The bare bulb is cheaper and re-uses your existing housing, but you move the bulb across yourself.
How long does the CM10 lamp last?
SP.8EH01GC01 is rated for 3,000 hours at 185 W. Actual life depends on the lamp mode you run and how the projector is ventilated.
Does the same lamp fit other Optoma projectors?
Yes. The same lamp also fits the Optoma CB300, the Optoma DH3303, the Optoma DM161, the Optoma DN244, the Optoma DP333, the Optoma DP3303 and other Optoma models listed on this page.