Maxell DT01881M projector lamp
The Maxell DT01881M takes lamp DT01881 . It comes as a complete module, with the bulb already fitted in its housing. The same lamp is also sold under 4 other part numbers, all listed below. It fits 4 Maxell models in total.
The code moulded into your old lamp or printed on its housing may be any of these. They are the same part. If the code on your lamp appears in this table, it fits the Maxell DT01881M.
| Code | Used by |
|---|---|
DT01881 | Maxell original part number |
456-8980WU | Equivalent code |
MC-WU8701Black | Equivalent code |
MC-WU8751Black | Equivalent code |
White | Equivalent code |
The code printed on your old lamp or its housing should match one of the codes listed above. Maxell and third-party suppliers sell the same lamp under several numbers.
The model number is on a label on the base or rear of the projector, and in the on-screen menu under Information. Still unsure? Send a photo of the old lamp and we'll confirm the match.
If your projector is one of these rather than the DT01881M, the same lamp is the correct part.
Which lamp does the Maxell DT01881M take?
The Maxell DT01881M uses DT01881, also sold as 456-8980WU, MC-WU8701Black, MC-WU8751Black, White.
Should I buy the bare bulb or the module?
This model's lamp is sold as a complete module: the bulb comes fitted in its housing, so you replace the whole unit in one piece.
How long does the DT01881M lamp last?
Rated life depends on the lamp mode you run and how the projector is ventilated; the lamp's own page lists the figure where the manufacturer publishes one.
Does the same lamp fit other Maxell projectors?
Yes. The same lamp also fits the Maxell DT01881, the Maxell MC-WU8701, the Maxell MC-WU8751.