Maxell DT01511 projector lamp
The Maxell DT01511 takes lamp DT01511 . It comes as a complete module, with the bulb already fitted in its housing. It fits 4 Maxell models in total.
The code moulded into your old lamp or printed on its housing may be any of these. They are the same part. If the code on your lamp appears in this table, it fits the Maxell DT01511.
| Code | Used by |
|---|---|
DT01511 | Maxell original part number |
The code printed on your old lamp or its housing should match one of the codes listed above. Maxell and third-party suppliers sell the same lamp under several numbers.
The model number is on a label on the base or rear of the projector, and in the on-screen menu under Information. Still unsure? Send a photo of the old lamp and we'll confirm the match.
If your projector is one of these rather than the DT01511, the same lamp is the correct part.
Which lamp does the Maxell DT01511 take?
The Maxell DT01511 uses DT01511.
Should I buy the bare bulb or the module?
This model's lamp is sold as a complete module: the bulb comes fitted in its housing, so you replace the whole unit in one piece.
How long does the DT01511 lamp last?
Rated life depends on the lamp mode you run and how the projector is ventilated; the lamp's own page lists the figure where the manufacturer publishes one.
Does the same lamp fit other Maxell projectors?
Yes. The same lamp also fits the Maxell DT01511M, the Maxell DT01518, the Maxell MC-CX301.