Jector JP840WX projector lamp
The Jector JP840WX takes lamp JP840WX-LAMP . It is available both as a complete module (bulb fitted in its housing) and as a bare bulb for re-using your existing housing. It fits 2 Jector models in total.
The code moulded into your old lamp or printed on its housing may be any of these. They are the same part. If the code on your lamp appears in this table, it fits the Jector JP840WX.
| Code | Used by |
|---|---|
JP840WX-LAMP | Jector original part number |
The code printed on your old lamp or its housing should match one of the codes listed above. Jector and third-party suppliers sell the same lamp under several numbers.
The model number is on a label on the base or rear of the projector, and in the on-screen menu under Information. Still unsure? Send a photo of the old lamp and we'll confirm the match.
If your projector is one of these rather than the JP840WX, the same lamp is the correct part.
Which lamp does the Jector JP840WX take?
The Jector JP840WX uses JP840WX-LAMP.
Should I buy the bare bulb or the module?
Both are available. The module is the bulb already fitted in its housing and is the quicker swap. The bare bulb is cheaper and re-uses your existing housing, but you move the bulb across yourself.
How long does the JP840WX lamp last?
Rated life depends on the lamp mode you run and how the projector is ventilated; the lamp's own page lists the figure where the manufacturer publishes one.
Does the same lamp fit other Jector projectors?
Yes. The same lamp also fits the Jector JP840XSP.