Eiki LMP28 projector lamp
The Eiki LMP28 takes lamp POA-LMP28, a 250 W lamp rated for 2,000 hours. It comes as a complete module, with the bulb already fitted in its housing. The same lamp is also sold under 5 other part numbers, all listed below. It fits 3 Eiki models in total.
The code moulded into your old lamp or printed on its housing may be any of these. They are the same part. If the code on your lamp appears in this table, it fits the Eiki LMP28.
| Code | Used by |
|---|---|
POA-LMP28 | Eiki original part number |
610 285 4824 | Equivalent code |
610-285-4824 | Equivalent code |
Experience 610 285 4824 | Equivalent code |
Experience 610-285-4824 | Equivalent code |
Experience POA-LMP28 | Equivalent code |
The code printed on your old lamp or its housing should match one of the codes listed above. Eiki and third-party suppliers sell the same lamp under several numbers.
The model number is on a label on the base or rear of the projector, and in the on-screen menu under Information. Still unsure? Send a photo of the old lamp and we'll confirm the match.
If your projector is one of these rather than the LMP28, the same lamp is the correct part.
Which lamp does the Eiki LMP28 take?
The Eiki LMP28 uses POA-LMP28, also sold as 610 285 4824, 610-285-4824, Experience 610 285 4824, Experience 610-285-4824, Experience POA-LMP28.
Should I buy the bare bulb or the module?
This model's lamp is sold as a complete module: the bulb comes fitted in its housing, so you replace the whole unit in one piece.
How long does the LMP28 lamp last?
POA-LMP28 is rated for 2,000 hours at 250 W. Actual life depends on the lamp mode you run and how the projector is ventilated.
Does the same lamp fit other Eiki projectors?
Yes. The same lamp also fits the Eiki LC-VC1, the Eiki LC-XC1.