Eiki LC-SX6DA projector lamp
The Eiki LC-SX6DA takes lamp 03-000881-01P, a 300 W lamp rated for 1,500 hours. It is available both as a complete module (bulb fitted in its housing) and as a bare bulb for re-using your existing housing. The same lamp is also sold under 3 other part numbers, all listed below. It fits 9 Eiki models in total.
The code moulded into your old lamp or printed on its housing may be any of these. They are the same part. If the code on your lamp appears in this table, it fits the Eiki LC-SX6DA.
| Code | Used by |
|---|---|
03-000881-01P | Eiki original part number |
610 315 7689 | Equivalent code |
610-315-7689 | Equivalent code |
POA-LMP80 | Equivalent code |
The code printed on your old lamp or its housing should match one of the codes listed above. Eiki and third-party suppliers sell the same lamp under several numbers.
The model number is on a label on the base or rear of the projector, and in the on-screen menu under Information. Still unsure? Send a photo of the old lamp and we'll confirm the match.
If your projector is one of these rather than the LC-SX6DA, the same lamp is the correct part.
Which lamp does the Eiki LC-SX6DA take?
The Eiki LC-SX6DA uses 03-000881-01P, also sold as 610 315 7689, 610-315-7689, POA-LMP80.
Should I buy the bare bulb or the module?
Both are available. The module is the bulb already fitted in its housing and is the quicker swap. The bare bulb is cheaper and re-uses your existing housing, but you move the bulb across yourself.
How long does the LC-SX6DA lamp last?
03-000881-01P is rated for 1,500 hours at 300 W. Actual life depends on the lamp mode you run and how the projector is ventilated.
Does the same lamp fit other Eiki projectors?
Yes. The same lamp also fits the Eiki LC-SX6, the Eiki LC-SX6A, the Eiki LC-SX6D, the Eiki LC-X6, the Eiki LC-X6A, the Eiki LC-X6D and other Eiki models listed on this page.